• New
Farm Solar PTZ Kit

Farm Solar PTZ (SD2X) Kit + 2 X CPE

R17,400.00

(R17,400.00 kit)

Tax included
Reference: Solar PTZ (SD2X) Kit + 2 X CPE

A off grid Pole Mount Solar kit that includes a PTZ camera with 18 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 to 36 hours with a recovery time from full discharge of less than 30mins at 50% solar power.

2 X Long distance CPE wireless units included 

***Product takes 3 days assembly time before shipping***

ON BACKORDER

  Delivery policy

All local packages are shipped via The Courier Guy with tracking and drop-off with signature.

SPECIFICATIONS – Solar Mount

Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware

Setting angle: 45° for capturing the correct angle for the sun

Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground

NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.

Wind load: 80Kkm/Hr

Hail loading: 1.1Kn/m ²

Assembled weight (includes 1 x 30W panel): 5kg

Attention: Edges may be sharp

Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.

Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.

SPECIFICATIONS – Control and Battery Cabinet

Depending upon the customer requirement, two battery pack options are available in the enclosure shown being6Ah or 12Ah.

Solar charging is by means of a Monocrystalline Solar panel


The solid state controller integrates all aspects required for optimal operation of the unit with:

  • Solar charge controller specifically for LiFepo4 cells with BMS on 12Ah unit
  • Regulated outputs for two cameras and a USB communication device
  • Raw output for a 12V - CPE link

Cabinet: Polyester / Polycarb 300 x 250 x 130mm

Pole mount bracket: U-clamp / strap top and bottom

Batteries: 1 x 12V12Ah LiFeP04 batt pack

Solar Charge Controller: 10A

Camera Voltage Protector: 2A

Connectivity

Supplied two CPE510 pre-configured as a bridge to connect your camera to your main site, line of sight up to 15KM.

Connect the one to the POE injector supplied in the kit and the other at your main site.

Power Connectors for: Camera; Router; Solar panels

Total Weight of control and battery cabinet: 8kg

Cabinet mounting set comes with:

1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),

4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts

 

Solar PTZ (SD2X) Kit + 2 X CPE

Specific References

New product

in the same category

Instagram