- New
Farm Solar PTZ (SD2X) security camera Kit-WiFi
R15,300.00
(R15,300.00 kit)
Tax included
Reference: Solar PTZ (SD2X) Kit-WiFi
A off grid Pole Mount Solar kit that includes a PTZ camera with 18 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 to 36 hours with a boot recovery time from full discharge of less than 30mins at 50% solar power.
Read our FAQ on Solar here.
***Please note client to provide pole and WiFi coverage, product takes 3 days assembly time before shipping***
SPECIFICATIONS – Solar Mount
Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware
Setting angle: 45° for capturing the correct angle for the sun
Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground
NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.
Wind load: 80Kkm/Hr
Hail loading: 1.1Kn/m ²
Assembled weight (includes 1 x 30W panel): 5kg
Attention: Edges may be sharp
Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.
Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.
SPECIFICATIONS – Control and Battery Cabinet
Depending upon the customer requirement, two battery pack options are available in the enclosure shown being 12Ah.
Solar charging is by means of a Monocrystalline Solar panel
The solid state controller integrates all aspects required for optimal operation of the unit with:
- Solar charge controller specifically for LiFepo4 cells with BMS on 16Ah unit
- Regulated outputs for two cameras and a USB communication device
- **** NO CPE - use the 24Ah for CPE
Cabinet: Polyester / Polycarb 300 x 250 x 130mm
Pole mount bracket: U-clamp / strap top and bottom
Batteries: 1 x 12V 16Ah LiFeP04 batt pack
Solar Charge Controller: 10A
Camera Voltage Protector: 2A
Connectivity
The SD2X camera support both 2.4 and 5GH Wi-Fi, so merely connect to your existing infrastructure
If you are looking for LTE(4G) connectivity then please look here:
If you are looking for long range point to point connectivity then please look here:
Power Connectors for: Camera; Router; Solar panels
Total Weight of control and battery cabinet: 8kg
Cabinet mounting set comes with:
1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),
4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts
Read our blog on off grid solar cameras HERE
Solar PTZ (SD2X) Kit-WiFi
1 Item
Specific References
New
in the same category
- Pack
- New
- Pack
- Pack
- Pack
- Pack
- New
- Pack
A off grid Pole Mount Solar kit that includes a PTZ camera with 18 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 to 36 hours with a boot recovery time from full discharge of less than 30mins at 50% solar power.
Read our FAQ on Solar here.
***Please note client to provide pole and WiFi coverage, product takes 3 days assembly time before shipping***