Farm Solar PTZ (SD2) Kit-WiFi
A off grid Pole Mount Solar kit that includes a PTZ camera with 4 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s
***Please note client to provide pole and 12V Router, product takes 3 days assembly time before shipping***
SPECIFICATIONS – Solar Mount
Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware
Setting angle: 45° for capturing the correct angle for the sun
Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground
NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.
Wind load: 80Kkm/Hr
Hail loading: 1.1Kn/m ²
Assembled weight (includes 1 x 30W panel): 5kg
Attention: Edges may be sharp
Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.
Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.
SPECIFICATIONS – Control and Battery Cabinet
Depending upon the customer requirement, two battery pack options are available in the enclosure shown being 12Ah.
Solar charging is by means of a Monocrystalline Solar panel
The solid state controller integrates all aspects required for optimal operation of the unit with:
- Solar charge controller specifically for LiFepo4 cells with BMS on 16Ah unit
- Regulated outputs for two cameras and a USB communication device
- **** NO CPE - use the 24Ah for CPE
Cabinet: Polyester / Polycarb 300 x 250 x 130mm
Pole mount bracket: U-clamp / strap top and bottom
Batteries: 1 x 12V 16Ah LiFeP04 batt pack
Solar Charge Controller: 10A
Camera Voltage Protector: 2A
An 4G GSM modem runs on any mobile network allowing you to connect to the system from virtually anywhere – as long as the system is in an area with good network coverage. Speeds of are location dependent.
(Sim Card– supplied by customer depending on your service provider)
Depending on your requirments you can use any router as long as it can be power by 12V.
We recommend something like the Mikrotik LtAP Mini LTE Router.
Power Connectors for: Camera; Router; Solar panels
Total Weight of control and battery cabinet: 8kg
Cabinet mounting set comes with:
1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),
4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts