Farm Solar PTZ (SD4) Kit-WiFi
A off grid Pole Mount Solar kit that includes a 4Meg 2K PTZ camera with 4 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s
50W solar pannel with a 20Ah battery pack
***Please note client to provide pole, product takes 3 days assembly time before shipping***
Read our FAQ on Solar here
Read our article on what size is best for you here
SPECIFICATIONS – Solar Mount
Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware
Setting angle: 45° for capturing the correct angle for the sun
Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground
NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.
Wind load: 80Kkm/Hr
Hail loading: 1.1Kn/m ²
Assembled weight (includes 1 x 50W panel): 5kg
Attention: Edges may be sharp
Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.
Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.
SPECIFICATIONS – Control and Battery Cabinet
Depending upon the customer requirement, two battery pack options are available in the enclosure.
Solar charging is by means of a Monocrystalline Solar panel
The solid state controller integrates all aspects required for optimal operation of the unit with:
- Solar charge controller specifically for LiFepo4 cells with BMS on 20Ah unit
- Regulated outputs for a camera and a USB communication device
- Unregulated output for CPE or LTE router
Cabinet: Polyester / Polycarb 300 x 250 x 130mm
Pole mount bracket: U-clamp / strap top and bottom
Batteries: 1 x 12V 20Ah LiFeP04 batt pack
Solar Charge Controller: 10A
Camera Voltage Protector: 2A
The camera is equipped with dual band Wi-Fi 2.4G/5G dual band, IEEE802.11b/g/n/ac, as long as you have Wi-Fi coverage at the location your good to go.
Power Connectors for: Camera; Router; Solar panels
Total Weight of control and battery cabinet: 8kg
Cabinet mounting set comes with:
1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),
4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts