• Pack
Farm Solar PTZ Kit

Farm Solar PTZ (SD2) Kit

R11,500.00

(R11,500.00 kit)

Tax included
Reference: Farm Solar PTZ (SD2) Kit

A off grid Pole Mount Solar kit that includes a PTZ camera with 4 X Optical zoom. This pole-mounted solar power kit uses Lithium battery’s that offer a Run (dark) time of 24 to 36 hours with a recovery time from full discharge of less than 30mins at 50% solar power.

***Please note client to provide pole and USB dongle, product takes 3 days assembly time before shipping***

This pack contains

IN STOCK - product takes 3 days assembly time before shipping

  Delivery policy

All local packages are shipped via The Courier Guy with tracking and drop-off with signature.

SPECIFICATIONS – Solar Mount

Pole mount for solar panel: Aluminium alloy brackets with stainless steel hardware

Setting angle: 45° for capturing the correct angle for the sun

Mounting pole (to be supplied by installer/customer for combination of solar panels and battery/control box): recommended minimum - 75mm x 3mm steel for 3metre above ground

NOTE: POLE is NOT INCLUDED in the kit and dimension are only a guideline. It is the responsibility of the client to ensure that correct erection procedure for the pole is followed.

Wind load: 80Kkm/Hr

Hail loading: 1.1Kn/m ²

Assembled weight (includes 1 x 30W panel): 5kg

Attention: Edges may be sharp

Solar panel mount set comes with: 1 upper bracket, 1 lower bracket, 2 x U-bolts (straps), 2 x M6 hex-head bolts, 4 x washers, 2 x M6 nyloc nuts, 2 x M6 hex-head bolts for solar panel, 4 x flat washers for solar panel, 2 x nyloc nuts for solar panel.

Installation: To the greatest extent possible, the installation site should allow unshaded exposure to the sun throughout daylight hours.

SPECIFICATIONS – Control and Battery Cabinet

Depending upon the customer requirement, two battery pack options are available in the enclosure shown being6Ah or 12Ah.

Solar charging is by means of a Monocrystalline Solar panel


The solid state controller integrates all aspects required for optimal operation of the unit with:

  • Solar charge controller specifically for LiFepo4 cells with BMS on 12Ah unit
  • Regulated outputs for two cameras and a USB communication device
  • Raw output for a 12V - CPE link

Cabinet: Polyester / Polycarb 300 x 250 x 130mm

Pole mount bracket: U-clamp / strap top and bottom

Batteries: 1 x 12V12Ah LiFeP04 batt pack

Solar Charge Controller: 10A

Camera Voltage Protector: 2A

Connectivity

An 4G GSM modem runs on any mobile network allowing you to connect to the system from virtually anywhere – as long as the system is in an area with good network coverage. Speeds of are location dependent.

(USB mobile LTE router– supplied by customer depending on your service provider)

Depending on your requirments you can use any router as long as it can be power by USB or else 12V. 

We recommend something like the Huawei E5577 Wireless Portable Router.

 

Power Connectors for: Camera; Router; Solar panels

Total Weight of control and battery cabinet: 8kg

Cabinet mounting set comes with:

1 upper bracket, 1 lower bracket, 2 x U-bolts (straps),

4 x M6 hex-head bolts, 8 x washers, 4 x M6 nyloc nuts

 

Farm Solar PTZ (SD2) Kit
3 Items

Specific References

New product

in the same category

Instagram